×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

problem !!=>Need help about "police cir" in MLS cisco 7604

Unanswered Question
Jul 20th, 2013
User Badges:

hi  all ,

i have MLS cisco 7604  ,


i tried to use QOS to dedicate  cir for specific  subnet ,  but  it  failed , it seems that bandwidth command dont work on that platform !!!


my 1st  question eis  can i apply QOS  and use bandwidth command ??? is it impossible ????


=============================================================================================



my 2nd question is ,

i have 600 M as total download traffic ,

i want to limit the bw on the interface from 600M  to 520 M


i  configured the following :

================================================

Gateway7600#

sh ip access-lists drvirus


Extended IP access list drvirus

     10 deny ip any x.x.x.0 0.0.0.31 (1802 matches)

     20 permit ip any any (2507719 matches)

=================================================

Gateway7600#

sh class-map drvirus


Class Map match-all drvirus (id 4)

    Match access-group name  drvirus

===================================================

Gateway7600#

sh policy-map drvirus


   Policy Map drvirus

     Class drvirus

police cir 500000000 bc 93750000 be 187500000

    conform-action transmit

    exceed-action drop

    violate-action drop

====================================================

Gateway7600#

sh running-config interface gigabitEthernet 1/5


Building configuration...


Current configuration : 258 bytes

!

interface GigabitEthernet1/5

description 7600to7200

mac-address 503d.e5af.9c45

ip address 172.30.40.2 255.255.255.252

ip wccp 70 redirect in

ip wccp 90 redirect in

load-interval 30

service-policy input drvirus

service-policy output rateupload

end

==========================================================================


but  when i try to put under the interface level ,

service-policy input drvirus

it fails  and give me the error ===>



Gateway7600(config-if)#service-policy input drvirus
burst (bc)  must be between 1000 and 31250000 for this interface
Configuration failed on GigabitEthernet1/5




i tried another  trial ,

i changed police cir  from 

police cir 500000000 bc 93750000 be 187500000

  to ===>  

police cir 500000000 bc 250000 be 1000


after that , it was accepted under the interface command.

but i dont see any limitation in bw !!!!!!!

wish to help me =============?


================================================


i have the following speifications :



Gateway7600#sh module

Mod Ports Card Type                                     Model                 Serial No.

--- ----- -------------------------------------- ------------------ -----------

   1    9  Supervisor Engine 32 8GE (Active)       WS-SUP32-GE-3B      SAD104204GX


Mod MAC addresses                            Hw   Fw              Sw             Status

--- ---------------------------------- ----- ------------- ------------ -------

   1  0018.bad2.2324 to 0018.bad2.232f  4.4   12.2(18r)SX   15.2(4)       Ok


Mod  Sub-Module                      Model                 Serial        Hw      Status

---- --------------------------- ------------------ ----------- ------- -------

   1  Policy Feature Card 3        WS-F6K-PFC3B        SAD104201HK  2.3    Ok

   1  Cat6k MSFC 2A daughterboard WS-F6K-MSFC2A       SAD104004UC  3.1    Ok


Mod  Online Diag Status

---- -------------------

   1  Pass

===================================================================

Gateway7600#sh version

Cisco IOS Software, c7600s3223_rp Software (c7600s3223_rp-ADVENTERPRISEK9-M), Version 15.2(4)S, RELEASE SOFTWARE (fc1)

Technical Support:

http://www.cisco.com/techsupport


Copyright © 1986-2012 by Cisco Systems, Inc.

Compiled Fri 20-Jul-12 18:18 by prod_rel_team


ROM: System Bootstrap, Version 12.2(17r)SX3, RELEASE SOFTWARE (fc1)

BOOTLDR: Cisco IOS Software, c7600s3223_rp Software (c7600s3223_rp-ADVENTERPRISEK9-M), Version 15.2(4)S, RELEASE SOFTWARE (fc1)


Gateway7600 uptime is 32 weeks, 7 hours, 6 minutes

Uptime for this control processor is 13 weeks, 7 hours, 10 minutes

System returned to ROM by power-on (SP by power-on)

System restarted at 06:26:11 UTC Sat Apr 20 2013

System image file is "sup-bootdisk:c7600s3223-adventerprisek9-mz.152-4.S.bin"

Last reload type: Normal Reload

Last reload reason: Reload Command




This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.


A summary of U.S. laws governing Cisco cryptographic products may be found at:


http://www.cisco.com/wwl/export/crypto/tool/stqrg.html



If you require further assistance please contact us by sending email to

[email protected].


cisco CISCO7604 (R7000) processor (revision 2.0) with 458752K/65536K bytes of memory.

Processor board ID FOX1509G2DK

R7000 CPU at 300MHz, Implementation 39, Rev 3.3, 256KB L2, 1024KB L3 Cache

Last reset from power-on

1 Virtual Ethernet interface

9 Gigabit Ethernet interfaces

1915K bytes of non-volatile configuration memory.


65536K bytes of Flash internal SIMM (Sector size 512K).

Configuration register is 0x2102

===================================================================================

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion