×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SX20 remote control

Answered Question
Jul 22nd, 2013
User Badges:

Hi everyone,


I´m so sorry for this question, is the Remote control for codec or camera? I want to say if i could locate the codec in datacenter and to use the remote control in meeting room to manage calls and other features.


I appreciate your help.

Correct Answer by Ravi Yadav about 4 years 3 weeks ago

Hi Juan,


no need to be sorry , question is a question


remote IR is on bothe camera and Codec can be used on both however  only one will work at a time.


Hope that helps


Thanks

Ravi kr

Endorsed by Magnus Ohm
Patrick Sparkman about 4 years 3 weeks ago

One things to note, that if the camera is connected to the codec using the it's control cable, than the IR on the codec will be disabled.  The camera's IR takes precedence over the codec's.


SystemUnit IrSensor Mode

Both the Codec C Series and PrecisionHD camera have IR sensors, and only one of them needs to be

enabled at the time. The IR sensor LED is located on the front of the codec and the camera and flickers

when an IR signal is received from the remote control.

Requires user role: ADMIN

Value space:

On: Enable the IR sensor on the codec.

Off: Disable the IR sensor on the codec.

Auto: The system will automatically disable the IR sensor on the codec if the IR sensor at camera is enabled. Otherwise, the IR sensor on the codec will be enabled.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
Correct Answer
Ravi Yadav Mon, 07/22/2013 - 08:17
User Badges:
  • Silver, 250 points or more

Hi Juan,


no need to be sorry , question is a question


remote IR is on bothe camera and Codec can be used on both however  only one will work at a time.


Hope that helps


Thanks

Ravi kr

Patrick Sparkman Mon, 07/22/2013 - 09:02
User Badges:
  • Purple, 4500 points or more
  • Cisco Designated VIP,

    2017 TelePresence

One things to note, that if the camera is connected to the codec using the it's control cable, than the IR on the codec will be disabled.  The camera's IR takes precedence over the codec's.


SystemUnit IrSensor Mode

Both the Codec C Series and PrecisionHD camera have IR sensors, and only one of them needs to be

enabled at the time. The IR sensor LED is located on the front of the codec and the camera and flickers

when an IR signal is received from the remote control.

Requires user role: ADMIN

Value space:

On: Enable the IR sensor on the codec.

Off: Disable the IR sensor on the codec.

Auto: The system will automatically disable the IR sensor on the codec if the IR sensor at camera is enabled. Otherwise, the IR sensor on the codec will be enabled.


juan_cye_ccna Wed, 07/24/2013 - 07:43
User Badges:

I appreciate your help. Thanks to Ravi and Patrick for the comments.

Actions

This Discussion