I am setting up wireless access points for a Church.
I acquired a couple of 1131AG access points, and flashed them into Autonomous mode successfully. I used the CLI to configure them to provide WiFi, 1 SSID only (it's just for parishoner access; the office will remain on a separate, existing WiFi network). It uses WPA2 encryption. An existing router will provide DHCP.
We want to redirect to a Welcome page when parishoners connect. I know that "Enable IP Redirection on this SSID" exists on the access point, but I'm unclear how to use it, and an extensive search (of the Support Community and the general Internet) didn't help.
Can anyone direct me as to how to do this? The Church has a website (hosted externally), and I could put a page there; alternately we could use a service (preferably free; we don't have much money). We don't run any servers at the Church building right now, and I'd rather not install one if I can avoid it.
Thanks in advance for the help!