×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ISE installation - reimaging issue

Unanswered Question
Jul 29th, 2013
User Badges:

Hi,


Today I was installing ISE on 3355 appliances those will run all services (standalone), when  installation completed I was not able to login to the CLI. I think the  keyboard I used had issue (typed extra charachter or something). This was a pre-loaded OS.


I downloaded (ise-ipep-1.2.0-899.i386.iso) and tried password recovery booting appliance with (ise-ipep-1.2.0-899.i386.iso), after changing the password I saved configs and tried  logging using the new password. But I could not login again.


Then I tried to re-install ISE using (ise-ipep-1.2.0-899.i386.iso).  After the installation was completed, I entered setup command and an error  poped up on the screen. "input/output errors occured while installation".


Question 1: Is the following iso only for a posture node installation or I could use this for ISE standalone deployment?


ise-ipep-1.2.0-899.i386.iso

Cisco Identity Services Engine Software Version 1.2.0 full  installation (IPN functionality only). This ISO file can be used for  installing ISE IPN (Inline Posture Node) on ISE-33x5 and NAC-33x5  Appliances, SNS-3415 server and CSACS-1121.


Question:2 What could have caused "input/output errors occured while installation". And how should I proceed with the installation?


I am in really bad situation, your help and support will be highly appreciated.


Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ravi Singh Mon, 07/29/2013 - 18:59
User Badges:
  • Cisco Employee,

Yes you are right the ise-ipep-1.2.0-899.i386.iso is used for installing ISE IPN. Might be you are using the corrupt software for Cisco Identity Services Engine. please download the latest software again. I installed the same and it’s working.

Mudasir Abbas Tue, 07/30/2013 - 10:19
User Badges:

Hi Ravi, Thanks for the reply but my questions were following..


Question 1: Is the following iso only for a posture node installation or I could use this for ISE standalone deployment?


Can I use this ise-ipep-1.2.0-899.i386.iso for fresh installation on 3355 appliance?



Question:2 What could have caused "input/output errors occured while  installation". And how should I proceed with the installation?


Answer: Download the latest version 1.2 and check the MD5 checksum.

Ravi Singh Wed, 07/31/2013 - 01:18
User Badges:
  • Cisco Employee,

Hello Mudasir,


I am checking that you will be able to deploye it in standalone mode or not. I will update the thread as soon as possible.

Venkatesh Attuluri Thu, 08/29/2013 - 06:41
User Badges:
  • Cisco Employee,

If you wish to do a standlone deployment use


Cisco  ISE Software Version 1.2.0 full installation(no IPN functionality).This  ISO file can be used for installing ISE on ISE-33x5, NAC-33x5  Appliances, SNS-34x5 Servers and CSACS-1121 as well as a VM installation  on VMWare ESX/ESXi 4.x/5.x


ise-1.2.0.899.x86_64.iso

Actions

This Discussion

Related Content