×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Can you use the range command for T1's?

Answered Question
Jul 30th, 2013
User Badges:

I'm trying to reset roughly a few dozen T1's.....This might take a while, is there a range command that I can use similar to the int range command for interfaces?

Correct Answer by Aman Soi about 4 years 2 weeks ago

Hi Ricci,


I do not think so.


You need to individually enter into controller port and do the shut/no shut or if T1s are coming from a single card of MUX of SP, then, that card could be reset.


regds,

aman

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Aman Soi Tue, 07/30/2013 - 18:59
User Badges:
  • Purple, 4500 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

Hi Ricci,


I do not think so.


You need to individually enter into controller port and do the shut/no shut or if T1s are coming from a single card of MUX of SP, then, that card could be reset.


regds,

aman

Actions

This Discussion