Unable to configure ACE 20s

bobby0110 · ‎08-07-2013

I am unable to enter config mode on an active ACE module.

Also, I don't even have the option for any 'sh ft' commands.

It might be an authorization issue with ACS but it doesn't give a 'command authorization fail' message when trying the command.

ACE1/Admin# ?

Exec commands:

changeto Changeto another context

configure Enter configuration mode

dir Directory listing for files

exit Exit from the EXEC

ping Send echo messages

show Show running system information

ssh SSH to another system

terminal Set terminal line parameters

traceroute Trace route to destination

xml-show Display xmlized show command result in xml

ACE1/Admin# configure

^

% invalid command detected at '^' marker.

Does this look like an authorization issue?

Thanks.

ciscocsoc · ‎08-09-2013

That is the error message you would see if the ACS was not setting the user role to Admin. See discussions at

for examples of what you need to configure.

HTH

Cathy

Cesar Roque · ‎08-09-2013

Hi Bobby,

The problem is the Role of the user you are using, is probably a network-monitor role. You can check with show users to confirm this.

You probably need to setup the shell attribute in the ACS

---------------------
Cesar R
ANS Team

--------------------- Cesar R ANS Team

Jorge Bejarano · ‎08-15-2013

Bob,

If you did not specify a role for your user and password, ACE will take the default which is Network-monitor

Jorge