Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Add digits to inbound digits before sending to Call Manager

Answered Question
Aug 14th, 2013
User Badges:

My current provider sends 10 digits and we are migrating to a new provider that will only send 7 digits.  I want to do make the migration easier by adjusting the dial peer in the gateway so that it sends the same digits to the Call Manager that are currently being sent.  How can I prepend our area code to the inbound digits?

dial-peer voice 2500 voip

description AT&T Test

preference 1

destination-pattern 994300[34]

session target ipv4:

dtmf-relay h245-alphanumeric h245-signal

codec g711ulaw

no vad

I have adjusted the destination-pattern to reflect the new 7 digits, but how can I add our area code before it is sent to Call Manager?

Correct Answer by George Thomas about 4 years 4 days ago

Hi Michael,

You will have to use a translation rules  to prefix the area code on the voip dial-peers.


Please rate useful posts.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
MICHAEL BURNS Wed, 08/14/2013 - 20:41
User Badges:

Thanks for the help.  BTW, how do you rate answers?  I must be missing something.

George Thomas Thu, 08/15/2013 - 11:47
User Badges:
  • Blue, 1500 points or more

Looks like you got it right. Thanks for the rating. Good luck!

Please rate useful posts.


This Discussion

Related Content