×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

10G link not coming up on WS6509-E switch

Unanswered Question
Aug 29th, 2013
User Badges:

Hi,


We have WS6509-E switch with WS-X6708-10GE module. When we try to connect the interface from WS-X6708-10GE module to 10GBase-SR connector on WS-C4500X-32 10G, interface is not coming up. Can anyone suggest us if there is compatibility issue between these modules.


I dont see any problem with the modules or connectors as on the same WS-X6708-10GE module .interface is coming up when connected to

10GBase-SR/SW connector.



Thanks,

Rupesh

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Reza Sharifi Thu, 08/29/2013 - 11:36
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

Hi,


6500 uses X2 module and 4500X uses SFP+.  Can you try swapping the strands around on the 6500 side since that is SC type connector and test again?

Also, are you using the correct optics and fiber patch on both sides?


HTH

Actions

This Discussion

Related Content