Solved: nexus 5548up loader> how to resolve this issue?

rvkcisco1 · ‎09-04-2013

loader> dir

bootflash:

lost+found

n5000-uk9-kickstart.5.1.3.N1.1a.bin

n5000-uk9.5.1.3.N1.1a.bin

mts.log

vdc_2

vdc_3

vdc_4

vlan.dat

MDS201309012310597480.lic

loader> boot n5000-uk9-kickstart.5.1.3.N1.1a.bin

Cisco Nexus Operating System (NX-OS) Software

TAC support: http://www.cisco.com/tac

The copyrights to certain works contained in this software are

owned by other third parties and used and distributed under

license. Certain components of this software are licensed under

the GNU General Public License (GPL) version 2.0 or the GNU

Lesser General Public License (LGPL) Version 2.1. A copy of each

such license is available at

http://www.opensource.org/licenses/gpl-2.0.php and

http://www.opensource.org/licenses/lgpl-2.1.php

switch(boot)#

How to recover from the mode

after reload the switch its going back to loader>

InayathUlla Sharieff · ‎09-04-2013

Rupesh,

I just finished from the same situation and resolved it

Please follow th document mentioned below;

http://www.cisco.com/en/US/docs/switches/datacenter/sw/password_recovery/nx_os_pw.html

Step 14 Boot the Cisco NX-OS kickstart image on the standby supervisor module, if necessary.

In the following example, the kickstart image filename is nx-os_kickstart.bin:

loader# boot bootflash:nx-os_kickstart.bin

Step 15 Load the Cisco NX-OS system software on the standby supervisor module, if necessary.

In the following example, the system image filename is nx-os.bin:

switch(boot)# load bootflash:nx-os.bin

Step 16 Save the configuration.

HTH

Regards

Inayath

***Plz don't forget to rate this post if this info is helpfull***************

View solution in original post

InayathUlla Sharieff · ‎09-04-2013