09-13-2013 01:42 AM - edited 07-04-2021 12:50 AM
Hello.
I have problem with login to AP in Cisco 881GW.
I have in running-config default config with memory on flash this router: dir flash: cpc-8xxx.cfg.
I write in EXEC mode:
service-module wlan-ap0 session
then i must put login and password to AP.
I write cisco/cisco and nothing.
I can't get mode AP. Authentic failed.
When i go to web interface I have same problem.
This link:
it doesn't help.
I can't find any answer in this posted threads.
Have you any ideas?
09-13-2013 06:59 AM
You have to add a username and password when you first log into the router. I believe the login banner warns you to do this otherwise you will be locked out.
You can factory reset the AP module, but you will lose any config in the AP. The command is:
service-module wlan-ap 0 reset default-config
Sent from Cisco Technical Support iPhone App
09-13-2013 01:30 PM
When I first time turn on the router I have:
yourname#
I do reset the AP module and I can't get mode AP. Authentic failed.
When I write:
sh controller wlan-ap0
I have nothing.
It is correct?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: