×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

command for changing gbic cards on switch

Unanswered Question
Reza Sharifi Fri, 09/13/2013 - 15:43
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

You can replace the card without using any commands.   The cards are hot swapable.


HTH

InayathUlla Sharieff Fri, 09/13/2013 - 17:19
User Badges:
  • Cisco Employee,

Reza,

Not sure what exactly is the question...but never the less yes as mentioned by you that we dont have any cmd to replace the card.


But I was thinking is the question beeing asked to change the Gbic from 10G to 1 Gig?

If yes then as you know the below command would do the trick:


#conf t

#hw-module module X port-group gig-interface ( This will convert 10 gig to 1 gig).


Ref:http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/sw_int.html


HTH

Regards

Inayath

Actions

This Discussion