Using Two ISP links on remote sites..

rite2anil · ‎09-15-2013

Hello,

I have a ISP links on my remote site's router on Gig 0/1 and now I am planning for a secondary link.Since, I have only two gig ports ( one is used by ISP link and other is used as LAN gateway),the other ISP is ready to provide secondary link on serial port.

I am using BGP as protocol and MPLS as a media. Kindly let me know what changes \ extra configurations I'll have to do for running my remote sites on either primary or secondary links ?

Thanks & Regards,

Anil Kumar

Lei Tian · ‎09-16-2013

Hi Anil,

You have some options to prefer one BGP route over the other. You need to consider the route preference on both direction, ingress and egress. I think the easiest way is to add as-path prepend on both direction of the secondard link.

HTH,

Lei Tian

rite2anil · ‎09-18-2013

Hi Lei,

I have the below configuration done in my remote router. Can you please send me sample config on the same ?

interface Loopback1
ip address 10.26.129.abc 255.255.255.255
!
!
interface GigabitEthernet0/0
description CONNECTED TO LAN F0/1
ip address 10.26.129.acb 255.255.255.224
duplex auto
speed auto
media-type rj45
!
!
interface GigabitEthernet0/1 //Currently used by primary ISP//
bandwidth 2048
ip address 10.26.129.pqr 255.255.255.252
duplex auto
speed auto
media-type rj45
no cdp enable
!
!
interface Serial0/0/0 // To Be used by second ISP//
no ip address
shutdown
clock rate 125000
!

router bgp xxxy
no synchronization
bgp log-neighbor-changes
network 10.26.129.acb mask 255.255.255.224 //LAN IP pool
network 10.26.129.abc mask 255.255.255.255   //Loopback IP address.
neighbor 10.cc.129.161 remote-as xxxx    //next hop of gig0/1 towards primary ISP
neighbor 10.cc.129.161 allowas-in 4      ////next hop of gig0/1 towards primary ISP
no auto-summary
!

Regards,

Anil Kumar

Lei Tian · ‎09-18-2013

Hi Anil,

If you are receiving same routes from both providers, the following config should work

router bgp xxxy

neighbor x.x.x.x remote-as xxx //secondary ISP

neighbor x.x.x.x route-map INBOUND in

neighbor x.x.x.x route-map OUTBOUND out

route-map OUTBOUND permit 10

set as-path prepend x x x x //local-as number

!

route-map INBOUND permit 10

set as-path prepend last-as 4

HTH,

Lei Tian