×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
John Blakley Fri, 09/20/2013 - 08:52
User Badges:
  • Purple, 4500 points or more

Are you wanting to use it as source/destination for the tunnel termination, or are you just wanting to advertise the loopback over the tunnel?



HTH,
John

*** Please rate all useful posts ***

csco11579831 Fri, 09/20/2013 - 08:58
User Badges:

hi John,

is to put in a next hop for route map,therefore, source / destination, is not it?

James,

John Blakley Fri, 09/20/2013 - 10:00
User Badges:
  • Purple, 4500 points or more

You can apply a next-hop to a tunnel interface. For example if you have 2 ends of a tunnel:


192.168.1.1 - side A

192.168.1.2 - side B


Your route-map on side A can set a next-hop to 192.168.1.2 to force traffic over the tunnel if needed....



HTH,
John

*** Please rate all useful posts ***

csco11579831 Fri, 09/20/2013 - 10:28
User Badges:

That is doesn't working,i wat just how set up a lookback whith a tunnel GRE plz,

Actions

This Discussion