×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Using LMS to find my non-ssh devices

Answered Question
Sep 26th, 2013
User Badges:

I have Cisco Prime LMS 4.2 deployed.  How can I use it to determine which of my routers and switches are not configured to support ssh?   Clearly I could log into each device and do it by trial and error but I'd like something a little more elegent.    I wasn't hopeing there is a best practices report or something already built in but I don't see it.


Thank you,

Tod

Correct Answer by AFROJ AHMAD about 3 years 10 months ago

Hi Tod,


so Basically  you need the get the Capabality of the devices with SSH


As per my understanding DIRECTLY it is not possible to get this , however I can suggest you one thing:


Create a CUSTOME INVENTORY Report


Report >report designer > Inventory


you can custom the report based on IMAGE  ( usually the IMAGES with K9 have the capabilty of SSH)


check the below link:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.2/user/guide/reports/inv_reports.html#wp1125269


Thanks-

Afroz

[Do rate the useful post]

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
AFROJ AHMAD Thu, 09/26/2013 - 22:01
User Badges:
  • Cisco Employee,

Hi Tod,


You can to check if the device are Configured with SSH  ?


Or you wanted to check if Device are capable of configuring the SSH  ?


Thanks-

Afroz

Tod Larson Fri, 09/27/2013 - 06:13
User Badges:

I want to figure out 2 things.


1. What devices are NOT capable of SSH.

2. What devices are capabile SSH but not currently configured for SSH.

Correct Answer
AFROJ AHMAD Fri, 09/27/2013 - 10:13
User Badges:
  • Cisco Employee,

Hi Tod,


so Basically  you need the get the Capabality of the devices with SSH


As per my understanding DIRECTLY it is not possible to get this , however I can suggest you one thing:


Create a CUSTOME INVENTORY Report


Report >report designer > Inventory


you can custom the report based on IMAGE  ( usually the IMAGES with K9 have the capabilty of SSH)


check the below link:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.2/user/guide/reports/inv_reports.html#wp1125269


Thanks-

Afroz

[Do rate the useful post]

Actions

This Discussion

Related Content