×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

FDM Email Notification Problem

Unanswered Question
Oct 1st, 2013
User Badges:

Hello every one

i have configured my cisco LMS Email Notification Group and evrything works fine sending and receving ,  excpet that the FDM sent the Email without displaying the Device Name only the IP address in the Object ID .

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
AFROJ AHMAD Tue, 10/01/2013 - 07:47
User Badges:
  • Cisco Employee,

Hi Mohamed,


By deafult DFM does not use the DCR Display Name. check the below link:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_device_fault_manager/3.2/user/guide/useDevMg.html#wp1367517


To overcome this :


1> Added the Device Name and IP address on the DNS Server


2> Modified NMSROOT/objects/smarts/conf/discovery/discovery.conf, and changed the DisplayNameFormat from "AUTOASSIGNED" to "MIBIISYSNAME". 


That caused DFM to display the sysName as the display name.


Also set the NameFormat to TM_USEAUTONAME, then restarted daemon Manager (net stop crmdmgtd && net start crmdmgtd )


Open name-resolver.conf file and make same changes that we have made in  discovery.conf.  ie, the following entry should be there in this file  also.



  #NameFormat = "TM_USESEEDNAME"


  NameFormat = "TM_USEAUTONAME"



3> Delete and re-add a device in DFM



Thanks-

Afroz

[Do rate the useful post]

Actions

This Discussion