×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ISDN 3241 Gateway Calling Party Number

Unanswered Question
Oct 9th, 2013
User Badges:

Hi all,


we struggeling a bit in order to config an isdn gateway 3241 behind a pbx from alcatel omni pcx enterprise.

Basicly is all working, but the calling party number is not completed.

Is there a way to set the byte 3 in isdn to "national" or "private" ?       

In addition to that, could someone explain the "national bits sa4...sa8" ? which isdn bit could be changed with that ?


Many thanks

/dirk

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Martin Koch Wed, 10/09/2013 - 15:26
User Badges:
  • Red, 2250 points or more

If you do not get a better answer (eg. by Cristian) and you have a service contract, think of opening

a service request and ask for configuration help.


Did you check on the options you find at the Settings ISDN page?


Could picture that the private flag is set untill you set "Specify national/international type of number".


Maybe its also related to  Send "sending complete" or Legacy capabilities.


If you have a pbx admin available I would play around with these options and let him check

what might work. Anyhow, there also might be the way to configure the PBX to make it work.





Please remember to rate helpful responses and identify helpful or correct answers.

Actions

This Discussion