×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Ciscoworks LMS and 2800 Switch Module Ports

Unanswered Question

We have a number of 2800 router on our network that have NM-16ESW= 16 port Ethernet modules installed. These are used to connect PCs and phones.


Everytime one of these ports goes down, usually due to a PC being powered down, we receive a critical alert in Ciscoworks.


The ports are configured not to log or send snmp traps.


no logging event link-status

no snmp trap link-status


How can we stop these alerts being generated?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marvin Rhoads Wed, 10/09/2013 - 08:24
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 Firewalling, Network Management, VPN

Most likely LMS is polling the interfaces. By default, interfaces that are up when the device was discovered are managed. You can unmanage interfaces by editing the device properties in LMS.

Actions

This Discussion