Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
962
Views
0
Helpful
3
Replies

Ciscoworks LMS and 2800 Switch Module Ports

tobin_jim
Level 1
Level 1

‎10-09-2013 07:57 AM

We have a number of 2800 router on our network that have NM-16ESW= 16 port Ethernet modules installed. These are used to connect PCs and phones.

Everytime one of these ports goes down, usually due to a PC being powered down, we receive a critical alert in Ciscoworks.

The ports are configured not to log or send snmp traps.

no logging event link-status

no snmp trap link-status

How can we stop these alerts being generated?

Labels:
0 Helpful
3 Replies 3

tobin_jim
Level 1
Level 1

‎10-09-2013 07:58 AM

I should have mentioned we are using LMS 4.0

0 Helpful

Marvin Rhoads
Hall of Fame
Hall of Fame
In response to tobin_jim

‎10-09-2013 08:24 AM

Most likely LMS is polling the interfaces. By default, interfaces that are up when the device was discovered are managed. You can unmanage interfaces by editing the device properties in LMS.

0 Helpful

tobin_jim
Level 1
Level 1
In response to Marvin Rhoads

‎10-09-2013 08:32 AM

Thanks for the reply Marvin. I'm a LMS novice so can you give an indication on where in LMS i can edit the device properties?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents