Here’s what I’m trying to do:
I have one VLAN on a HP 1810 24 port switch (latest firmware) that supports VLANs. On this VLAN I have 2 DHCP servers running on W2k12. This DHCP server has two scopes: 192.168.1.x and 192.168.2.x. The default gateway to the internet is 192.168.1.1 and is a DLink router connected to the switch. All machines are currently on the 192.168.1.x VLAN.
I bought a Cisco RV180-K9-NA to handle the second VLAN (192.168.2.x). I would like to have the RV180 route all traffic to the switch for local traffic and internet traffic through the switch to the gateway 192.168.1.1. I would also like the RV180 to forward all DHCP requests to the two DHCP servers. I would like to do this by forwarding the broadcasts but if I have to provide just a single IP for the DHCP Relay I can live with that.
If possible I would like to use the RV180 WAN port to connect to the switch and the other 4 ports for machines. But if I have to use 1 of the 4 ports as the uplink to the switch I could live with that as well.
I spent a full day trying to get all this to work without success. Any guidance would be greatly appreciated.