×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Iker Santamaria... Mon, 10/14/2013 - 14:23
User Badges:

Hello,
First of all, you must check boot configuration and where you put the IOS image.

Copy the same IOS image than it's on active supervisor, in the standby supervisor, poweroff chasis and extract active supervisor.

Now, following this procedure:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_configura...

Best regards.

Sent from Cisco Technical Support iPad App.

Actions

This Discussion