×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

WLC4136 Wirless Controller and Network Projectors

Unanswered Question

I have a WLC4136 wireless controller with AP1020 access points.

The wireless network runs fine.


I have recently purchased an NEC P350W projector.

It has network projecting capabilites.  I have the projector wired into our network as it has a LAN port


One can connect to the projector (Win 7 - All Programs > Accessories > Connect to a networked projector)


When I am connected via a wired LAN connection the PC will find the projector and connect with no problems.


When I connect via a wireless connection going through my WLC4136 it can not see the projector and will not connect.


Any advice on getting the network projector to be seen and connectable to on the wireless?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion