10-17-2013 07:45 AM - edited 07-04-2021 01:06 AM
I have a WLC4136 wireless controller with AP1020 access points.
The wireless network runs fine.
I have recently purchased an NEC P350W projector.
It has network projecting capabilites. I have the projector wired into our network as it has a LAN port
One can connect to the projector (Win 7 - All Programs > Accessories > Connect to a networked projector)
When I am connected via a wired LAN connection the PC will find the projector and connect with no problems.
When I connect via a wireless connection going through my WLC4136 it can not see the projector and will not connect.
Any advice on getting the network projector to be seen and connectable to on the wireless?
11-14-2013 01:17 PM
I fixed it.
Went to
Controller > General
Enabled Ethernet Multicast Mode
11-14-2013 11:24 PM
thank you for sharing the info.. you Rock
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: