×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
anirudh.wna Mon, 10/21/2013 - 01:53
User Badges:

is it a new switch.


check if,


1.if you have the settings right in hyperterminal/putty/minicom etc..

2.if a different console cable is workig in this switch.

3 you are connecting to the correct console port !!

4.if you have any ip address configure in the switch, try to telnet/ssh to it.

junaid haroon Mon, 10/21/2013 - 02:37
User Badges:

HI,

my switch is old one


i have checked all senarios but still facing same issue

anirudh.wna Mon, 10/21/2013 - 02:43
User Badges:

isn,t there any config inside. what is the model of your switch. did'nt you create any int vlan with any ip?? can you recall.. by any chance does  your switch support usb console cable??

Actions

This Discussion