Hello,
I start setup of new RV220W Wireless router.
I want to provide access to internal network via PPTP.
But gettting error 'PPTP Start IP Address must not be in the subnet of LAN:192.168.1.1/255.255.255.0'.
I reviewed the forum and some user's says what they can fix this issue, but I cannot found the way how to do it.
Details of router:
| Firmware Version | 1.0.4.17 | ||
| LAN (Local Network) Configuration | |||
| IP Address | (xxx.xxx.xxx.xxx) | ||
| Subnet Mask | (xxx.xxx.xxx.xxx) | ||
| DHCP | |||
| DHCP Mode | |||
| Domain Name | |||
| Starting IP Address | (xxx.xxx.xxx.xxx) | ||
| Ending IP Address | (xxx.xxx.xxx.xxx) | ||
| Primary DNS Server | (Optional) | ||
| Secondary DNS Server | (Optional) | ||
| Lease Time | Hours (Range : 1 - 262800, Default : 24) | ||
| Remote DHCP Server | |||
| LAN (Local Network) Proxy | |||
| DNS Proxy | Enable | ||
| VLAN | Enable |
Create VLANs and assign the Outgoing Frame Type.
Up to Fifteen new VLANs can be created. VLAN IDs must be in the range (2 - 4093)
| VLAN ID | Description | Inter VLAN Routing | Device Management | Port 1 | Port 2 | Port 3 | Port 4 | ||
| 1 | Default | Enabled | Enabled | Untagged | Untagged | Untagged | Untagged |
Multiple VLAN Subnet Table
| VLAN ID | IP Address | Subnet Mask | DHCP Mode | DNS Proxy Status | ||
| 1 | 192.168.1.1 | 255.255.255.0 | DHCP Server | Enabled |
VPN Users
| PPTP Server | Enable | |
| Starting IP Address | (xxx.xxx.xxx.xxx) |  PPTP Start IP Address must not be in the subnet of LAN:192.168.1.1/255.255.255.0 |
| Ending IP Address | (xxx.xxx.xxx.xxx) |
 | | | | | | |||||
| No. | Enabled | Username | Password | Allow User to Change Password | Protocol | |||||
| 0 results found | ||||||||||
All settings after reset to factory settings.
How I can enable assigning the IPs from LAN network to the PPTP Server?
Thank you!
