×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

NTP server error

Unanswered Question
Oct 27th, 2013
User Badges:

Hi All

I have problem in NTP server I configured my Domain server as ntp server when add the ntp server in the cucm 7 Pub by ip of my domain server (192.168.1.7)  the status showing  "The NTP service not accessible".


I login the ssh to the call mamager server ssh


admin:utils ntp status

ntpd (pid 19919) is running...



     remote           refid      st t when poll reach   delay   offset  jitter

==============================================================================

127.127.1.0     LOCAL(0)        10 l   63   64    1    0.000    0.000   0.004

192.168.1.7     .INIT.          16 u    -   64    0    0.000    0.000 4000.00





unsynchronised

  time server re-starting

   polling server every 64 s



Current time in UTC is : Sun Oct 27 12:25:19 UTC 2013

Current time in Asia/Riyadh is : Sun Oct 27 15:25:19 AST 2013



Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
islam.kamal Sun, 10/27/2013 - 06:16
User Badges:
  • Red, 2250 points or more

Hi


It is recommended to use IOS devices as routers , as your gateway. Please find the below config;-


ntp master 1

ntp source loopback 0

ntp server X.X.X.X


clock timezone SA ( )

clock summer-time SA recurring


Then on your CUCM- OS - add ntp -use the Ip address of your looback


Thank you

Please rate all useful information

Actions

This Discussion