NTP server error

Abdo Ahmed Saleh Al-Kaf · ‎10-27-2013

Hi All

I have problem in NTP server I configured my Domain server as ntp server when add the ntp server in the cucm 7 Pub by ip of my domain server (192.168.1.7) the status showing "The NTP service not accessible".

I login the ssh to the call mamager server ssh

admin:utils ntp status

ntpd (pid 19919) is running...

remote refid st t when poll reach delay offset jitter

==============================================================================

127.127.1.0 LOCAL(0) 10 l 63 64 1 0.000 0.000 0.004

192.168.1.7 .INIT. 16 u - 64 0 0.000 0.000 4000.00

unsynchronised

time server re-starting

polling server every 64 s

Current time in UTC is : Sun Oct 27 12:25:19 UTC 2013

Current time in Asia/Riyadh is : Sun Oct 27 15:25:19 AST 2013

Thanks

islam.kamal · ‎10-27-2013

Hello

Abdo , if you use Windows as NTP server , there is a problem to synchronize with Cisco CUCM linux OS.Please find the below link

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCte17541

Thank you

Please rate all useful information

islam.kamal · ‎10-27-2013

Hi

It is recommended to use IOS devices as routers , as your gateway. Please find the below config;-

ntp master 1

ntp source loopback 0

ntp server X.X.X.X

clock timezone SA ( )

clock summer-time SA recurring

Then on your CUCM- OS - add ntp -use the Ip address of your looback

Thank you

Please rate all useful information

Aman Soi · ‎10-27-2013

Hi Ahmed,

Please refer these link which was discussed recently

https://supportforums.cisco.com/message/4072574#4072574

regds,

aman