×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

IPSec VPN over 4G router

Unanswered Question
Oct 30th, 2013
User Badges:

                   Hi ,

We need to build LAn-to-LAN VPN tunnel over Cisco 819-4G router and ASA FW.On our router 4G working fine and , but myCelluar 0 interface picking up dynmic ip address in 10.0.0.0 range. I have done NAT over load to cellular interface and can brows internet from V:AN 1 (172.16.1.1 NAT inside).

But I am not sure how to setup VPN with celuar0 interface because its getting dynamice privat ip from service provider.Is there any way or workaround.



Regards,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
smith606306 Wed, 10/30/2013 - 08:29
User Badges:

I am having the same issue. I am picking up a 10.0.0.0 address from o2

smith606306 Wed, 10/30/2013 - 09:08
User Badges:

so i think we would  initiate the connection from the router end. similar to VPN from home into the network

Actions

This Discussion