AIR-CAP3602I-A-K9 Module

Unanswered Question
Oct 30th, 2013
User Badges:

We just purchased a 3600AP (5 of them).


We added the AC Module (AIR-CAP3602I-A-K9) to each AP. Rebooted AP with the AC module added.

The AP joined in the controller, BUT, the AC radios shown as DOWN. The A N B and G radios are up and running and fine.


Is there anything that it must be done in the controller or the AP to enable the AC module radios?


Here is whats shown in my Radios tab


AP NameRadio Slot#Base Radio MACSub BandOperational StatusLoad ProfileRadio RoleNoise ProfileInterference ProfileCoverage ProfileCleanAir Admin StatusCleanAir Oper Status
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Wed, 10/30/2013 - 14:20
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Firstly, you need at least 20.0w PoE for the modules to power up.


Next, you may need to upgrade your firmware to 7.5. 


And finally, make sure your modules regulatory domain matches up with your AP.  It could be because your AP is "-A" and your module has a different regulatory domain.

Abha Jha Wed, 10/30/2013 - 21:06
User Badges:
  • Cisco Employee,

AP's are not getting enough power and hence the radio's are down...It happens in most of the cases..

Actions

This Discussion