linksys SRW208G does not run after Factory Defaults...?

Hristo Todorov · ‎10-31-2013

I had to Restore the switch to Factory Default...now when i connect to PC via ethernet I am not able to access it.

I have HyperTerminal...I am able to connect to the switch- I tried changing the IP address but still not able to access via WEB

Please help

Tom Watts · ‎10-31-2013

Hi Chris, can you verify the HTTP access is enabled when you're using the console access?

Do you have a link light when you connect your computer to the RJ45 connection?

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Hristo Todorov · ‎10-31-2013

Yes I have both lights on.

Tom Watts · ‎10-31-2013

Okay, is the switch plugged in to your network?

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Hristo Todorov · ‎11-04-2013

Sorry for the late reply, Tom...

No the switch is plugged only in my computer...