×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
daniel.dib Fri, 11/01/2013 - 08:22
User Badges:
  • Silver, 250 points or more

According to the feature navigator there should be support for it. Which version and license are you running?


However I can't find the command in the command reference. That's strange.


I did find it in an older configuration guide though http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_50_se/configuration/guide/swadmin.html#wp1053923


Maybe something changed in newer versions. Is ther nothing available if you do ntp questionmark


Daniel Dib
CCIE #37149

Rolf Fischer Fri, 11/01/2013 - 09:17
User Badges:
  • Blue, 1500 points or more

no. nothing comes up on ntp ?


Please forgive me the question but you tried this in global configuration mode, right?

In contrast to the "clock set" command, NTP is part of the switch configuration.

Rolf Fischer Fri, 11/01/2013 - 11:40
User Badges:
  • Blue, 1500 points or more

Hm, and your privilege level is 15 (show privilege)?

Or maybe there is a TACAC+ server which limits the commands you're allowed use?

And could you also please answer Daniel's question regarding IOS version and licence?

harris_732 Sat, 11/02/2013 - 05:01
User Badges:

well.. I am a naive and I am preparing for the CCNA. I am using a Packet Tracer v6.0.1.

Rolf Fischer Sat, 11/02/2013 - 05:47
User Badges:
  • Blue, 1500 points or more

OK, so that's obviously a limitation on PT.

PT seems to support NTP on the routers and on the c3560's but not (yet) on the c2960's - maybe it will in a future version.

You always have to keep in mind that PT is a just simulation and it has some limitations. But if you don't have access to real equipment, it's certainly better than nothing.

On a real c2960, you could enable NTP for sure.


Regards

Rolf


P.S.: CSC-contributors normally won't expect that you're using PT, so please mention that in your postings!

harris_732 Sat, 11/02/2013 - 08:38
User Badges:

hmm ok. Yes PT supports NTP on routers but not on switches. I will mention the use of PT in future. Thanks alot

Rolf Fischer Fri, 11/01/2013 - 08:29
User Badges:
  • Blue, 1500 points or more

12.2(55)SE - Administering the Switch: Configuring NTP

With 12.2(58)SE they introduced NTP version 4 and changed that part of the configuration guide but I remember we had c2960 running that IOS version and they still supported the command. And I'm pretty sure it is supported as well in older IOS releases.


HTH

Rolf

Actions

This Discussion