WAN Load Alarm Script Modification

Unanswered Question
Nov 7th, 2013
User Badges:

Hello Joesph,

You may recall sometime ago I asked if it were possible to modify the attached script to allow for more than one interface. At the time you mentioned that it wasn't possible.

I was just wondering if you had created a script (or modified the existing script) that would send an alert when the utilization on more than one interface crossed a certain threshold?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Thu, 11/07/2013 - 16:43
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Sorry, no.  This was not something I've been looking into.


This Discussion