cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
753
Views
5
Helpful
1
Replies

VCS Licenses

Hello friends,

can you please tell me what are these license about:

116341G00-1-9BEE730C - H323-SIP Interworking Gateway

116341P00-1-63797C52 - Device Provisioning

116341X10-1-A5700786 - 10 Non-traversal Calls

116341Y100-1-F7EACAC0 - 100 Traversal Calls

One friend told me that if a have a license the VCS will turn line some kind of firewall and the "Endpoint" can register to the VCS only with opening ports

on the ASA. Can you please tell me if this is true and what kind of license should i have that JabberVideo can register to the VCS.

VCS--Cisco3945--ASA5505------Internet-------Endpoint
THANKS!
1 Reply 1

Jens Didriksen
Level 9
Level 9

116341G00-1-9BEE730C - H323-SIP Interworking Gateway

Allows interworking between H.323 and SIP calls, i.e. you might be calling an end-point using SIP, but if the called end-point only supports H.323, the VCS will convert the call from SIP to H.323 and the call will still connect.

116341P00-1-63797C52 - Device Provisioning

This is required if you want to provision devices and/or clients such as JabberVideo.

116341X10-1-A5700786 - 10 Non-traversal Calls

Non-traversal calls are "internal calls", i.e. SIP-->SIP or H.323-->H.323 calls on your internal network where the media is not routed. This licence allows 10 concurrent calls of that nature.

See https://supportforums.cisco.com/thread/2155852

and for an in depth explanation see

http://www.cisco.com/en/US/docs/telepresence/infrastructure/articles/vcs_traversal_call_license_usage_kb_168.shtml .

116341Y100-1-F7EACAC0 - 100 Traversal Calls

This licence allows 100 concurrent traversal calls - see the above link for in depth explanations, however a call is known as a traversal call when interworked between h.323 and SIP, IPv4 and IPv6, firewall traversal etc.

One friend told me that if a have a license the VCS will turn line some kind of firewall and the "Endpoint" can register to the VCS only with opening ports

on the ASA. Can you please tell me if this is true

VCS--Cisco3945--ASA5505------Internet-------Endpoint
THANKS!

If the endpoints are all located behind the firewall, then you do not need to open any ports on the ASA to allow these end-points to register.

If you want to call end-points outside the firewall, then that is a different story all together.

You would normally go VCS--->FW-->VCS-E-->Internet which gives you secure firewall traversal.

See

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_IP_Port_Usage_for_Firewall_Traversal_Deployment_Guide_X4_to_X7.pdf

See this document for ports:https://supportforums.cisco.com/docs/DOC-18565

what kind of license should i have that JabberVideo can register to the VCS.

You need TMS JabberVideo aka provisioning licences if you want to use enterprise JabberVideo.

So:

1) TMS server

2 ) JabberVideo (Provisioning licences) installed on TMS server

3) TMSPE (Provisioning Extension) installed on TMS server

4) Provisioning templates created from provisioning schemas and uploaded to TMS server.

5) Provisioning key on VCS (which you have).

I strongly recommend you reach out to your local Cisco rep for this.

/jens

Please rate replies and mark question(s) as "answered" if applicable.

Please rate replies and mark question(s) as "answered" if applicable.