TMSXE in NON Active Directory Mode

rfrome · ‎11-12-2013

HI,

One of the options for installing TMSXE 3.1.2 is in non AD Mode

Installing with Non-AD mode

To be able to run Cisco TMSXE in Non-Active Directory mode, launch the Cisco TMSXE installer with the

following command line switch :

-NONADCONNECTIONMODE

I can not seem to get this commandline switch to be accepted. Does someone have an example of the correct syntax?

thx,

rf

rfrome · ‎11-12-2013

Additional info
Appendix 1

http://www.cisco.com/en/US/docs/telepresence/infrastructure/tmsxe/install_guide/Cisco_TMSXE_install_guide_3-1-2.pdf

anybody have success using this commandline switch?

rfrome · ‎11-13-2013

worked with TAC to get this figured out. The correct syntax is

msiexec /i TMSXESetup.msi NONADCONNECTIONMODE=1

A documentation defect has been opened with ID: CSCul18387

Hopefully that will help someone in the future.

Chow Dao Kun · ‎07-22-2014

Hi,

is there anyway to revert back to AD mode after installation?

thx

Kjetil Ree · ‎07-23-2014

Not without loss of data. If you really want to do this, please open a service request with TAC to get dedicated support in assessing your particular deployment.

A word of advice for others who are considering installing TMSXE in non-AD Mode: This option was introduced to support a couple of customers who had very specific requirements. 99.5% of customers do not have Exchange deployments where these conditions apply. Don't install TMSXE in non-AD Mode unless you have discussed it with your Cisco account team and agreed that this is right for you.

Regards,
Kjetil