×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Shared line on CME between a FXS port & ip phone

Answered Question
Dec 4th, 2013
User Badges:

Hi


Some on please tell whether we can share a DN between the analog phone configured on FXS port & with cisco ip phone on CME.The fxs port is configured on the CME.

Correct Answer by Rob Huffman about 3 years 8 months ago

HI Sulfi,


Yes, this is supported with SCCP endpoints


Cheers!

Rob



"When it comes to luck you make your own  " 

- Springsteen

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Rob Huffman Wed, 12/04/2013 - 07:10
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

HI Sulfi,


Yes, this is supported with SCCP endpoints


Cheers!

Rob



"When it comes to luck you make your own  " 

- Springsteen

sulfi salahudeen Wed, 12/04/2013 - 07:20
User Badges:

HI Rob


Below is my config.They are not ringing together & the analog phone rings only when they FWD the ip phone to the extension 777.

====

sccp local Loopback10

sccp ccm X.X.X.X identifier 1 version 4.1

sccp

!

sccp ccm group 1

bind interface Loopback10

associate ccm 1 priority 1

associate profile 1 register CNFRN1


===

voice-port 2/0/4

==

dial-peer voice 777 pots

destination-pattern 777

port 2/0/4

=====

ephone-dn  1  dual-line

number 777

label Reception Desk

name Reception Desk

call-forward busy 498

call-forward noan 498 timeout 15

=

ephone  1

mac-address 001A.2F80.411A

username "ReceptionDesk"

type 7961 addon 1 7914 2 7914

button  1:1 7m5 8m41 9m4

button  10m11 11m9 13m14 14m16

button  15m6 16m19 17m56 18m22

button  19m48 20m38 21m25 22m61

button  23m31 24m32 25m33 26m34

button  27m35 28m2 29m42 30m43

button  31m44 32m45 33m29 34m47

Actions

This Discussion