×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to create readonly user account on 3925 router?

Unanswered Question
Dec 5th, 2013
User Badges:

Hi, I have cisco rt3925 (C3900e Software (C3900e-UNIVERSALK9-M), Version 15.2(2)T1, RELEASE SOFTWARE (fc1)).


I want to create a user level 5 with right to only view the show run configuration.


I have applied this configuration in other cisco device and works fine, but I have problem with this router model (i have more than one 3925)


conf t

username user-backup privilege 5 secret PASSWORD

privilege exec level 5 show running-config view full


Then, I login with the user "user-backup", checked the privilege level but when I run "show run view full" nothing shows

arli002cirt3925#show privilege

Current privilege level is 5

arli002cirt3925#show run view full

arli002cirt3925#


So, can anyone help me out?


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
cadet alain Fri, 12/06/2013 - 00:05
User Badges:
  • Purple, 4500 points or more

Hi,


This command is RBAC( view keyword), you should try sh run full instead.


Regards


Alain



Don't forget to rate helpful posts.

Fernando Mantero Fri, 12/06/2013 - 12:42
User Badges:

Thanks for your answer.

I tried "privilege exec level 5 show running-config full" but when I run "show running-config full" nothing shows


Any idea?

Fernando Mantero Thu, 12/19/2013 - 21:05
User Badges:

Hi There,


Still looking for some help here.


Any help would be much appreciated


Thanks

cadet alain Fri, 12/20/2013 - 01:25
User Badges:
  • Purple, 4500 points or more

Hi,

I did some testing and  research and I'm sorry but my first reply was wrong.

conf t

username user-backup privilege 5 secret PASSWORD

privilege exec all level 5 show running-config view full


I tested it and it works.


Regards


Alain




Don't forget to rate helpful posts.

Fernando Mantero Fri, 12/27/2013 - 04:47
User Badges:

Hi, I added:

username networking_backup privilege 5 secret PASSWORD

privilege exec all level 5 show running-config view full


But no change.

It works OK with switches, but no with router


Thanks anyway


Another idea?

santiagoyanez Fri, 02/28/2014 - 07:02
User Badges:

Hi,

I also have this problem in the same model Router. may already have the solution ?


Cisco IOS Software, C3900e Software (C3900e-UNIVERSALK9-M), Version 15.2(4)M3, RELEASE SOFTWARE (fc2)


conf t

username test privilege 5 secret test

privilege exec all level 5 show running-config view full


CISCO3925#show privilege

Current privilege level is 5


CISCO3925 # show running-config view full

CISCO3925 #


can anyone help me ?


Thanks

Actions

This Discussion

Related Content