×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Maximum Characters In A Single Command

Unanswered Question
Dec 5th, 2013
User Badges:

Hello,


Is there a way to increase the maximum allowed characters in a single IOS command? I am trying to configure a big list of vlans in "encapsulation dot1q" command in ASR903 but I am reaching a point where I am unable to add any new character. I noticed this character count limitation is the same across IOS/IOS-XE, is this limit configurable?


service instance trunk 1 ethernet

  encapsulation dot1q 55,58-60,.......



regards,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content