×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Serial0/1/0 is up, line protocol is down (disabled)

Unanswered Question
Dec 10th, 2013
User Badges:

Hi,


I just connected my two routers with serial interfaces but they're unable to communicate. And sh int serial 0/1/0 is showing like that.


Here the output from one of the routers:


Router1#show interfaces se

Router1#show interfaces serial 0/1/0

Serial0/1/0 is up, line protocol is down (disabled)

  Hardware is HD64570

  Internet address is 11.0.0.2/30

  MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation HDLC, loopback not set, keepalive set (10 sec)

  Last input never, output never, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/75/0 (size/max/drops); Total output drops: 0

  Queueing strategy: weighted fair

  Output queue: 0/1000/64/0 (size/max total/threshold/drops)

     Conversations  0/0/256 (active/max active/max total)

     Reserved Conversations 0/0 (allocated/max allocated)

     Available Bandwidth 96 kilobits/sec

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     0 packets input, 0 bytes, 0 no buffer

     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

     0 packets output, 0 bytes, 0 underruns

     0 output errors, 0 collisions, 1 interface resets

     0 output buffer failures, 0 output buffers swapped out

     0 carrier transitions

     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

Router1#


Please help me out of this.


Regards,

Chandu

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content