×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Show Command Killed 6509???

Unanswered Question
Dec 10th, 2013
User Badges:

Good Morning,


Can anyone tell me why issuing the following command would drive the processor utilization 100%?


sh ip device tracking all           


This effectively took the switch offline until we resolved the issue by clearing the vty lines.  The following message was listed in the log 4 times:


%IP_DEVICE_TRACKING-4-TABLE_LOCK_FAILED: Table already locked byprocess-id 130(SSH Process)


This 6509 is functioning as a L2 access switch and has a very minimal config - only features running are dhcp snooping and 802.1x.  Other engineers in my company use this command on 6509s (same IOS) daily with no issues.  Unfortunately, I am unable to post any specific config info so I am just curious if anyone else has encountered this issue as I would love to know how a show command caused this issue.


Thanks,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion