×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Sg300-28P updated firmware no ports active

Unanswered Question
Dec 16th, 2013
User Badges:

           I updated the firmware to the latest version. Reset the switch after the bios update. The only problem I have now is none of the gi ports are active. I can get into the CLI. What command do I need to activate all the ports. It says links are down.


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Tom Watts Mon, 12/16/2013 - 15:40
User Badges:
  • Green, 3000 points or more

Hi Paul, you can use the command set interface active or you can try to config t , interface range x - x and no shut.

If that doesn't work you may want to call the SBSC to investigate.



-Tom
Please mark answered for helpful posts

Actions

This Discussion