12-26-2013 09:04 PM - edited 07-04-2021 11:51 PM
Hi ,
I have ordered Cisco CAP2602i access points , the software ordered was MESH ,is there any way we can change the software to RECOVERY after we received the WAP.
Thanks in advance.
Regards ,
mahesh
12-26-2013 09:10 PM
You can add the ethernet MAC address of the AP on to WLC mac filter (secuirty -> MAC filter) & then you can register this AP as a Mesh AP. Then you can change the mode to Local.
Otherwise you can upload the recovery image onto the AP via TFTP. Pls see the below for more detail
http://mrncciew.com/2013/12/13/ap-conversion-using-mode-button/
HTH
Rasika
*** Pls rate all useful responses ****
12-26-2013 10:47 PM
Thanks Rasika, Does Local mode here mean automonous ? or is it the recovery image.
12-27-2013 12:20 AM
No, Local mode mean the standard Light Weigth Access point mode (Not Autonomous)
HTH
Rasika
**** Pls rate all useful responses ****
12-27-2013 11:00 AM
Try this,
debug capwap console cli
test mesh mode local
Thanks,
Sahil
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: