×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Call speeds.

Unanswered Question
Dec 27th, 2013
User Badges:

I give a mxp 95 at a far location over a satellite link at 512 k. When I try to establish a call to it from the mcu the max rate the call will establish at is 192k. There is no max bandwidth set on the codec or mcu. Any ideas

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Patrick Pettit Fri, 12/27/2013 - 13:07
User Badges:
  • Cisco Employee,

Hard to tell. You can run xcon and xstat to see the config and status of the system. Then run: syslog on, place the call so we can see whats be requested in both directions for BW etc. Should to see. 192 for video? What audio codec is in use?

VR
Patrick


Sent from Cisco Technical Support Android App

Wayne DeNardi Sun, 12/29/2013 - 15:10
User Badges:
  • Green, 3000 points or more
  • Cisco Designated VIP,

    2017 TelePresence

Hi Paul,


Does the call estabish at a different rate if your dial it in the opposite direction (endpoint to MCU)?  Could help to pinpoint where the cause of the issue is, on the endpoint, or on the MCU, or something else?


Wayne

--

Please remember to rate responses and to mark your question as answered if appropriate.

Actions

This Discussion

Related Content