×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SG300-10 switch commands not working

Unanswered Question
Jan 2nd, 2014
User Badges:

Hey guys


New to all this so be kind


I have an SG300-10 switch and have connected to the switch by telent and SSH, but when I run commands like 'enable' is tells me 'Unrecognized command'


The firmware is Version 1.3.0.62, I checked it looks like a new version is available, do I need to upgrade the firmware? If so are there any steps I need to follow to upgrade the firmware without bricking the switch?




EDIT: Ok so I tried the command conf t which worked, why does enable not work? Is it because the CLI is not IOS?




Thanks


Matt

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
viningele Fri, 01/03/2014 - 03:46
User Badges:

Yep, the IOS commands have different levels.  You'll need to use the CLI command specific to the SG series since there are many differences.

Actions

This Discussion