×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Ciscoworks LMS 4.0 – Email Notifications Issue

Answered Question
Jan 3rd, 2014
User Badges:

We currently use Ciscoworks LMS 4.0 with over 1000 devices in the database. I'm a LMS novice. And have been assigned the task of minimising the amount of email notification’s we receive, as if one device goes Operationally Down all devices off that switch also send alerts to the email notification group, which in turn overwhelms the mailbox.


The ports are configured not to log or send snmp traps.


no logging event link-status

no snmp trap link-status


So any advice on how we can limit these alerts being generated would be much appreciated.


Thanks in advance.

Correct Answer by AFROJ AHMAD about 3 years 7 months ago

Hi Nessie,


Go to Monitor > Fault Settings > Setup > Fault Device Details


select the device and click on view  then Click on the hyperlink or the device name\ip address


that will bring a new window from there click on Interface and chanaged the Managed state from ture to FLASE for those interfaces for which you do not want ALERTS.


Thanks-

Afroz

[Do rate the useful post]

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
AFROJ AHMAD Fri, 01/03/2014 - 08:38
User Badges:
  • Cisco Employee,

Hi Nessie,


Go to Monitor > Fault Settings > Setup > Fault Device Details


select the device and click on view  then Click on the hyperlink or the device name\ip address


that will bring a new window from there click on Interface and chanaged the Managed state from ture to FLASE for those interfaces for which you do not want ALERTS.


Thanks-

Afroz

[Do rate the useful post]

Actions

This Discussion

Related Content