01-03-2014 11:02 AM - edited 03-07-2019 05:21 PM
So, I have two 3850's I want to put in a closet. Do I stack them or just leave them stand alones... My plan was to connect each to the core switch using fiber and users on each switch.
When I conenct the switches using the stackwise cable, I have an active and standby... Is there a way to make the standby a member? is the standby in true "standby" mode? Can I use the ports on the standby switch?
SO many questions Apppriecte any help..
Thanks
Solved! Go to Solution.
01-03-2014 12:05 PM
You should stack them, you paid a lot for that feature There is a master switch and the rest of the switches are members. There is no standby that's "waiting" like in firewalls. All switches and switchports are active so you can use them all!
01-03-2014 12:46 PM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
BTW, when you stack your pair, ideally, you still want an uplink from each switch. Depending on L2/L3 configuration, on both your stack and core device, you should be able to use the bandwidth from both links to/from the stack too. Also, if possible, try not to have the two links terminate on same line card on your core device, to avoid that also being a single point of failure.
01-03-2014 12:05 PM
You should stack them, you paid a lot for that feature There is a master switch and the rest of the switches are members. There is no standby that's "waiting" like in firewalls. All switches and switchports are active so you can use them all!
01-03-2014 12:46 PM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
BTW, when you stack your pair, ideally, you still want an uplink from each switch. Depending on L2/L3 configuration, on both your stack and core device, you should be able to use the bandwidth from both links to/from the stack too. Also, if possible, try not to have the two links terminate on same line card on your core device, to avoid that also being a single point of failure.
01-03-2014 01:18 PM
Awesome. Thank you very much.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: