cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
479
Views
0
Helpful
7
Replies

wism cannot access through web

susim
Level 3
Level 3

Hi ,

One of the  wism controller in the module  cannot access throuh the web interface . ( ican access the second controller in the same module without any problem )

It may work after 2 -3 reboot or power off the module  for sometimes .After sometime the same problem happens 

Operational Status of the Controller : Oper-Up

Modular switch model : C6513

Please help

Thanks

7 Replies 7

Leo Laohoo
Hall of Fame
Hall of Fame

Post the output to the command "sh wism module X controller Y status".

Operational Status of the Controller : Oper-Up

Service VLAN                         : 200

Service Port                         : 9

Service Port Mac Address             : 001a.xxxx.xxxx

Service IP Address                   : 172.10.129.3

Management IP Address                : 10.0.2.10

Software Version                     : 4.2.207.0

Port Channel Number                  : 525

Allowed-vlan list                    : 14,27,37-41

Native VLAN ID                       : 27

WCP Keep Alive Missed                : 0

Software Version                     : 4.2.207.0

I think you need to upgrade the firmware of your controller. 

It may work after 2 -3 reboot or power off the module  for sometimes .After sometime the same problem happens 

This description is typical of a firmware bug.  If you need to choose a good version, go with 7.0.240.X.

Don't forget to upgrade the bootstrap.

We use ap1020 (aironet) , we tried to upgrade the controller  .Once the controller upgraded  AP'S are not connecting to the controller

Lat IOS support for 1020 AP is 4.2.209.0.

check this mtrix sheet: http://www.cisco.com/en/US/docs/wireless/controller/5500/tech_notes/Wireless_Software_Compatibility_Matrix.html

Regards

We use ap1020 (aironet) , we tried to upgrade the controller  .Once the controller upgraded  AP'S are not connecting to the controller

Hmmmm ... Maybe the issue could be the version of your web browser. 

Sandeep Choudhary
VIP Alumni
VIP Alumni

Hi,

Can u please paste the output of the command: show network status

If you sse these commands is disabled then please enabled it agin :

WLC > config network ssh enable

WLC > config network webmode enable

WLC > config network secureweb enable

There was a bug in the wisms and the workaround  was to reload the controller.

If u have 2 wism then please Move over the APs and reload that WLC , that should fix it.

Hope it helps.

Regards

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: