01-06-2014 01:39 AM - edited 07-04-2021 11:53 PM
Hi ,
One of the wism controller in the module cannot access throuh the web interface . ( ican access the second controller in the same module without any problem )
It may work after 2 -3 reboot or power off the module for sometimes .After sometime the same problem happens
Operational Status of the Controller : Oper-Up
Modular switch model : C6513
Please help
Thanks
01-06-2014 01:42 AM
Post the output to the command "sh wism module X controller Y status".
01-06-2014 01:59 AM
Operational Status of the Controller : Oper-Up
Service VLAN : 200
Service Port : 9
Service Port Mac Address : 001a.xxxx.xxxx
Service IP Address : 172.10.129.3
Management IP Address : 10.0.2.10
Software Version : 4.2.207.0
Port Channel Number : 525
Allowed-vlan list : 14,27,37-41
Native VLAN ID : 27
WCP Keep Alive Missed : 0
01-06-2014 02:04 AM
Software Version : 4.2.207.0
I think you need to upgrade the firmware of your controller.
It may work after 2 -3 reboot or power off the module for sometimes .After sometime the same problem happens
This description is typical of a firmware bug. If you need to choose a good version, go with 7.0.240.X.
Don't forget to upgrade the bootstrap.
01-06-2014 02:25 AM
We use ap1020 (aironet) , we tried to upgrade the controller .Once the controller upgraded AP'S are not connecting to the controller
01-06-2014 02:27 AM
Lat IOS support for 1020 AP is 4.2.209.0.
check this mtrix sheet: http://www.cisco.com/en/US/docs/wireless/controller/5500/tech_notes/Wireless_Software_Compatibility_Matrix.html
Regards
01-06-2014 02:31 AM
We use ap1020 (aironet) , we tried to upgrade the controller .Once the controller upgraded AP'S are not connecting to the controller
Hmmmm ... Maybe the issue could be the version of your web browser.
01-06-2014 02:04 AM
Hi,
Can u please paste the output of the command: show network status
If you sse these commands is disabled then please enabled it agin :
WLC > config network ssh enable
WLC > config network webmode enable
WLC > config network secureweb enable
There was a bug in the wisms and the workaround was to reload the controller.
If u have 2 wism then please Move over the APs and reload that WLC , that should fix it.
Hope it helps.
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: