Searched forums and blogs, this has got me stumped and I hope someone can help.
I have a new install, seems the AP can find the controller but the radios will not come up.
The AP is directly connected to the controller by a 70m cable run.
Checked the regulatory domain, all UK.
I’ve attached when I get from a console cable during an AP boot, but my research have been around the following:
*Jan 10 14:07:08.495: %CAPWAP-3-ERRORLOG: Invalid event 10 & state 5 combination.
*Jan 10 14:07:08.495: %CAPWAP-3-ERRORLOG: CAPWAP SM handler: Failed to process message type 10 state 5.
*Jan 10 14:07:08.495: %CAPWAP-3-ERRORLOG: Failed to handle capwap control message from controller
*Jan 10 14:07:08.495: %CAPWAP-3-ERRORLOG: Failed to process encrypted capwap packet from 10.10.10.20
*Jan 10 14:07:08.827: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to administratively down
Any help greatly appreciated.
Go Wireless > 802.11a/n > Networks
You can enable the 802.11a radios from there.
Go Wireless > 802.11b/g > Networks
You can enable 802.11b/g radios from there.
State of 802.11b Network......................... Disabled
State of 802.11a Network......................... Disabled
Uhhhhhh ... This is the main reason why your radios are down. I found it in the first file, the "sh sysinfo".