Display called number on Jabber PC

cesarestan · ‎01-15-2014

Hello

I have Cucm 9.1.2.10000-28 and I have CSF device for PC Jabber.

When i make an externalcall on mobile the I remove prefix 0 and add 98 followed by mobile number,
on VG I have the following dial-peer

!
dial-peer voice 31 pots
tone ringback alert-no-PI
description CHIAMATE USCENTI su bri0/0/0 con #
destination-pattern 98T
fax rate disable
direct-inward-dial
port 0/0/0
!

So this procedure works but on display of Jabber and on history of Jabber i have 98 followed by number.

Is it possible to display on Jabber effective number ?
is it possible to have on historical call 0 followed by effective number?

Thanks a lot for your help

Cesare

Hermanus Janse van Vuuren · ‎01-15-2014

You can do it with a voice translation pattern on your VG where you bring the mobile number in and on the dialpeer your translation profile outgoing you can strip the zero and add the 98 or take the number without the zero and add the 98

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

Sent from Cisco Technical Support iPhone App

Best Regards

cesarestan · ‎01-15-2014

Hello

I did understand how the voice traslation will be used in my issue.

Just make trasformation of number from client Jabber to VG:

client make 03xxxxx (mobile call) -> mach pattern 03.! predot and prefix 98 so i on vg i have 983xxxx

in following dial peer strip 98 and call correctly 3xxxx but on jabber display i have 983xxxx and in history too.

On call manger in service parameters i found in device this parameter:

Name Display for Original Dialed Number When Translated

but doesn't work

thanks

Cesare

Hermanus Janse van Vuuren · ‎01-15-2014

then you can have a look under call routing at Transformation Patterns => Called Transformation Pattern, create a CSS and PT for that apply it to the DevicePool of the Jabber phones.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/9_0_1/ccmcfg/CUCM_BK_CDF59AFB_00_admin-guide_chapter_0110000.html

http://www.cisco.com/en/US/docs/voice_ip_comm/cucmbe/admin/7_0_1/ccmcfg/b03cldpt.pdf

Best Regards

cesarestan · ‎01-15-2014

Hello

I make in service parameter

Always Display Original Dialed Number in true

with this parameter in true works and on jabber i have 03xxx on display and in history too.

Hermanus Janse van Vuuren · ‎01-15-2014

well that is great news!... congrats.

Best Regards