How to load configuration using Cisco USB port???

Answered Question
Jan 20th, 2014
User Badges:
  • Почетные Знаки Сообщества,

    Новичок, Январь 2014

on USB-flush configuration there. I try to download it gives this:


Switch#copy usbflash0: 3560-ST

Source filename [3560-st]?

Destination filename [3560-ST]?

%Error opening usbflash0:3560-st (File not found)


What is the Problem? flash formatted on most Cisco (it has decreased in numbers from 16 GB to 2.75 GB)???

Correct Answer by Collin Clark about 3 years 6 months ago

If you are copying the config from USB to the running config-


copy usbflash0:conf-file-name running-config


If you want to copy the running config to USB-


copy running-config usbflash0:

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
chandra_rc16 Mon, 01/20/2014 - 22:28
User Badges:

Hope this helps.


copy usbflash0:filename.txt



Regards,
Chandu

Amit Singh Tue, 01/21/2014 - 03:25
User Badges:
  • Cisco Employee,

Syntax is the one as Chandu poined out.


However, i see there is a space between usb0: and the filename.


"Switch#copy usbflash0: 3560-ST"


Make sure there is no space in the syntax above and also the file name is correct.

Egor Khomenko Tue, 01/21/2014 - 19:25
User Badges:
  • Почетные Знаки Сообщества,

    Новичок, Январь 2014

Thank you so much. It would seem a trifle. But, I had a little brain naprech. It is a trifle, which I came twice

Correct Answer
Collin Clark Tue, 01/21/2014 - 10:56
User Badges:
  • Purple, 4500 points or more

If you are copying the config from USB to the running config-


copy usbflash0:conf-file-name running-config


If you want to copy the running config to USB-


copy running-config usbflash0:

pieterh Tue, 01/21/2014 - 12:39
User Badges:

Depending on the model, the internal flash may allready be refernced with usbflash0
If so the external USB may be usbflash1

Sent from Cisco Technical Support iPad App

Actions

This Discussion