Accepted Solutions
Yes, the numbers look ok, at least for a single 8510 blade.
The backdraw is that even if you would dial in with a low resolution device
it will still take one full hd port.
I would recomend you to look into the conductor and the telepresence server.
(Contact your Cisco Partner or Representative regards converting a 8510 to
a telepresence blade and condidtions for the Conductor).
That combination would give you a dynamic port allocation method, so depending
on the scenario you could get more users on it.
(from the TPS release notes:)
Please remember to rate helpful responses and identify helpful or correct answers.
Yes, the numbers look ok, at least for a single 8510 blade.
The backdraw is that even if you would dial in with a low resolution device
it will still take one full hd port.
I would recomend you to look into the conductor and the telepresence server.
(Contact your Cisco Partner or Representative regards converting a 8510 to
a telepresence blade and condidtions for the Conductor).
That combination would give you a dynamic port allocation method, so depending
on the scenario you could get more users on it.
(from the TPS release notes:)
Please remember to rate helpful responses and identify helpful or correct answers.
